I made companion earrings to wear with my beaded pendant — the image-transfer one. While I was looking up stitches to use, I ran into a tutorial by Bronzepony Beaded Jewelry for exactly the design I had in mind! That’s the second time this month I’m running into ready-to-use recipes for stuff that I want to make. (The first one was for my latest knitting project.)
For these earrings, I used the size-8 green beads and smaller size-15 brown beads that I’d used for the pendant. I made 12 units of Cubic Right Angle Weave (CRAW) with the larger beads, and embellished them with the smaller beads — one small bead between two large ones on the inner curves of the cubes, and two small beads in a similar fashion on the outer curves.
CRAW was not difficult to understand at all — not all difficult. I mean, it’s way too easy to imagine constructing a cube — first a floor, then walls, then ceiling. The execution of the first unit, though, was a different matter. Invariably, while I pulled the thread through the beads, I would lose my grip on the tiny setup that I created thus far, and then, it would be extremely difficult to bring the orientation back to where I was, and figure out which bead to go into next. I would just turn and turn the connected beads in my hand, all the while scratching my head. I tried to use the stop bead as reference, but it didn’t work for me. I even tried Jill Wiseman’s ‘taco’ style of construction, but with similar confusions.
After a couple of failed starts, I solved the problem by threading my stop bead into position at the center of the reinforced first square. That helped provide a ‘proper’ reference point for me. It was smooth sailing from then on.
When I was done constructing the drops, I threaded a couple of faux pearl beads into head pins, and attached each pearl-duo to a piece. I made eye loops at the top, and added ear wires to complete the earrings.